A backyard pool is a great asset during an Australian summer. It also comes with legal responsibilities. If you own a pool in New South Wales, the law requires you to keep its safety barrier compliant at all times. Preparing well for your pool certification in NSW saves time, money and the hassle of a second inspection.
Under the Swimming Pools Act 1992, you must register your pool on the NSW Swimming Pool Register. You also need a valid certificate of compliance before you sell or lease a property with a pool. Local councils and accredited certifiers carry out inspections, and a certificate is generally valid for three years.
Most failed inspections come down to small, fixable issues. Work through the steps below before you book an inspection, and fix any problems early.
Check Your Pool Fence
Fencing is the main focus of any inspection. Pool barriers must meet the relevant Australian Standard, AS 1926.1. Check that:
- The fence is at least 1.2 metres high from finished ground level.
- The gap under the fence is no more than 100 mm.
- Gaps between vertical bars are no more than 100 mm.
- Panels are secure, with no rust, cracks or loose fixings.
Walk the full perimeter and push on each panel. Measure gaps again if soil, mulch or pavers have shifted.
Clear the Non-Climbable Zone
The outside of the fence needs a 900 mm non-climbable zone. Remove anything a child could use to climb over, such as:
- Pot plants
- Chairs
- Barbecues
- Eskies
- Toys
Trim overhanging branches and shrubs. Check the neighbour’s side of any boundary fence as well.
Test Gates and Latches
Gates cause many inspection failures. Your gate must:
- Swing outwards, away from the pool.
- Self-close from any open position.
- Self-latch without help.
- Have a latch release at least 1.5 metres above the ground, or a shielded latch.
Test the gate from fully open, half open and slightly open. Tighten hinges, adjust spring tension and lubricate moving parts.
Display the Correct CPR Sign
You must display a current resuscitation sign that follows Australian Resuscitation Council guidelines. Place it where people can easily see it from the pool area. Replace any faded, damaged or outdated sign.
Inspect Doors and Windows
For most pools, house doors must not open directly into the pool area. Windows that open into the pool area need restrictors that limit the opening to 100 mm, or fixed security screens. Check each one carefully.
Keep the Water Clean
Inspectors focus on barriers, but clear water still matters. It lets the inspector view the pool properly and reduces health and safety risks. Test chlorine and pH levels, clean the filter and remove debris before the visit.
Gather Your Paperwork
Have these documents ready for the inspector:
- Your pool registration certificate.
- Any previous compliance certificates.
- Approvals for fencing or recent pool works.
Do a Final Walk-Through
Check everything again the day before the inspection. If your pool fails, you will receive a notice listing the defects and a timeframe to fix them. A reinspection, often with an extra fee, follows. Careful preparation gives you the best chance of passing the first time.

